Thursday, September 18, 2014

EN 222 Technopolymer Plastic Hinges with 4 Indexing Positions

Among our latest new products is our EN 222 Technopolymer Plastic Hinges with 4 Indexing Positions, available in metric sizes.

These RoHS-compliant hinges are very stable, and notable for a high resistant torque of 3 Nm in four indexing positions. All detent positions have a guaranteed resistant torque of ~3 Nm (which is the torque that must be applied to free the detent device of the hinge). This hinge has been tested with more than 20.000 opening and closing cycles, and the value of the resistant torque was unchanged.

Hinges are made of matte black glass fiber reinforced plastic (Polyamide PA), with hinge pin of stainless steel, European Standard No. 1.4305 (American Standard Series 303). They are offered in two types: 2x2 bore for DIN 7991-M6 countersunk screws, and 2x2 bore for ISO 4014-M6 countersunk screws.

To view our entire selection of Access Hardware, visit Section 3 of our online catalog.

Thursday, September 4, 2014

GN 51.7 Retaining Magnet Assemblies with Ball Knob or Key Ring, with Rubber Jacket

Today we're sharing with you our new series GN 51.7 Retaining Magnet Assemblies with Ball Knob or Key Ring, with Rubber Jacket, in metric sizes.

These RoHS-compliant magnet assemblies have a zinc-plated steel housing and a magnet of neodymium, iron and boron (NdFeB). The rubber jacket is made of black Elastomer (TPE). Assemblies are offered with matte black technopolymer plastic (Polyamide PA) ball knob or nickel-plated steel key ring.

These retaining magnet assemblies with rubber jacket are especially suitable for applications where the surface is easily marred. Also, the magnets have an increased coefficient of friction, which creates high lateral retaining force. They are temperature resistant to 175 °F (80°C). Offered diameters are 22, 31 and 43 mm, with nominal pulling forces of 35, 75 and 85 N respectively.

To see our full line of retaining magnets, visit Section 11 of our online catalog.