Tuesday, January 26, 2016

GN 1130 Steel Lifting Pins

Today we'd like to tell you about our new GN 1130 Steel Lifting Pins, available in metric sizes.

These RoHS-compliant lifting pins are carrier elements designed for fast and easy use. Pressing the red aluminum button will release the locking effect of the locking balls, allowing the load pin to be moved in or out of the holding bore hole. The shackle rotates by at least 180°, with a safety flange fitted as a safeguard against inadvertent operation. Depending on the direction of pull, the ball load pin may move freely by 360° in the holding bore hole.

These lifting pins alleviate the need to have lifting gear (e.g. load rings) permanently with the workpiece. Holding bore holes with d1 H11 tolerance are adequate for use.

Stud and shackle are made of heat-treated, manganese phosphated steel. Push button is red anodized aluminum. Spring is made of stainless steel. Lifting pins can support nominal loads from 1.5 to 4.8 kN.

To see our full line of Lifting Eyes and Load Rings, see Section 11 of our online catalog.

No comments:

Post a Comment